Salve a tutti. Ho da poco installato sul mio pc la mandrake 10.1 e ho un problema con le porte usb :da quanto ho letto, avendo una scheda madre Via, risulta incompatibile. Ho letto la tua citazione
Error scenario: Some motherboards based on VIA chipsets have USB-related problems with 2.6.x kernels.
Why: This problem is due to USB support with these motherboards, although the number of problematic motherboards is decreasing with each new kernel revision. You can see evidence of the problem with boot-time syslog messages such as:
usb 1-1: control timeout on ep0in
and
usbfs: USBDEVFS_CONTROL failed (...) ret -110
Solution: Add any or all of the following boot kernel parameters to your /etc/lilo.conf file: "acpi=off", "noapic", or "nolapic". Execute "lilo -v" to update the LILO configuration. After boot, execute the following commands:
# modprobe -r uhci-hcd
# modprobe uhci-hcd
You may also elect to use the 2.4.x kernel.
ma volevo chiederti: i parametri "acpi=off", "noapic", "nolapic" dove vanno esattamente inseriti, se con le virgolette o senza, perchè appena ne inserisco uno e mando il comando lilo -v, mi dice che il comando non è stato riconosciuto o sopra alla riga x. Cortesemente ti chiedo se puoi editarmi il file funzionante, visto che sono alle prime esperienze. Grazie.