Moderatori: Dylan666, piercing
quizface ha scritto:trovato in rete:
OK, after a nightmare setup with almost no instructions from USROBOTICS, I have figured the procedure to setup the print server on the USR5461 for WinXP. I have connected the 5461 to my HP5100 multi-function printer. I did update the firmware on the 5461 before figuring this out (download from usr support site), but I am not sure this is a necessary step.
Step 1: Plug your printer directly into your computer and install all typical drivers so that the printer functions fine across your usb cable. If your printer is already setup fine across a usb cable, you can skip this step.
Step 2:Conect your printer to the USR 5461.
Step 3:Go to Control panel then open printers and faxes.
Step 4:On the Top left select "Add a printer" to start the Wizard. Click next.
Step 5:On the Local or network printer setup box select "A network printer", then press next.
Step 6:On the Specify a Printer box select "Connect to a printer on the internet or network". Then in the URL space type:»192.168.2.1:1631/printers/My_Printer (this is case sensitive, you might want to cut and paste this). Then press next. (do not type the >> next to the url address; it was added by this forum's software).
Step 7 (Trust me on this one, it was a source of much frustration) On the Add a Printer wizard box whichever printer is selected by default (e.g. Agfa-AccuSet v52.3) leave selected, and press OK. (It doesn't matter which printer is selected at this point). The drivers will automatically load.
Step 8:On the Default printer box select yes. Press next.
Step 9:Press finish.
Step 10:Next right click the new default printer you've created on the printers and faxes screen, and select properties.
Step 11:Select the advanced tab. In the driver box press the drop-down arrow and select the actual printer you have connected to the USR 5461. Press apply. After the Change has been applied press the "General" tab.
Step 12: Press the "Print test page" button to test your new settings. After celebrating your success press OK and you are done.
Good luck all!
davide72 ha scritto:hai provato ad installare il driver della stampante per winxp ?
davide72 ha scritto:oltre al driver installato tramite server print , devi far riferimento anche al driver aggiornato prelevandolo dal sito HP , devi vedere te
davide72 ha scritto:scusa ma il servizio in questione viene installato dal programma mica dal windows , però non so che tipo di programma , ecco perchè non lo trovi nei servizi
controlla da msconfig se cè qualche voce disattivata all' avvio oppure guardare nelle funzionalita di windows
problema ricezione notifiche outlook Autore: gianscooby |
Forum: Sistemi Operativi Windows Risposte: 2 |
Excel: problema con date se devo unirle a testi Autore: valle1975 |
Forum: Applicazioni Office Windows Risposte: 5 |
Visitano il forum: Nessuno e 5 ospiti