problema con masterizzatore nec nd 7550a e toshiba satellite

[zizzi]

HO ACQUISTATO UN MASTERIZZATORE NEC ND-7550A DA MONTARE SUL MIO NOTEBOOK TOSHIBA SATELLITE M30 MA DOPO AVERLO MONTATO ALL'ACCENSIONE DEL PC MI APPARE UN MESSAGGIO D'ERRORE CHE INDICA 0203 : failure ide#2 COSA POSSO FARE PER RIOSOLVERE QUESTO PROBLEMA PERCHè ANCHE PERCHè IN QUESTO MODO MI è DIFFICILE PERSINO FORTMATTARE IL MIO PC. GRAZIE

[quizface]

leggi queste note:

Check point for built in PC
1) CSEL Setting (Master/Slave)
NEC Standard setting is : Low = Master, Open=Slave
However, some PC has reverse setting - in case NEC standard setting Drive is mounted to such reverse setting PC, Drive may not be recognized. Needs careful confirmation of Drive and PC.
2) Needs Bezel Figure Confirmation
Drive Bezel may not be compatible with the current drive. - Needs to confirm Bezel attachment form.
3) Connector/Enclosure form of Slim Drive
Since NEC Slim Drive is based on Standard, most Drives on market are compatible. However, some PC manufacturers may use connectors incompatible with NEC Drives - Needs prior confirmation for connector compatibility.

prese da http://www.nec.co.jp/products/optical/e ... ndex.shtml

Probabilmente non hai settato bene Master/Slave o Cable Select

[zizzi]

leggi queste note:

Check point for built in PC
1) CSEL Setting (Master/Slave)
NEC Standard setting is : Low = Master, Open=Slave
However, some PC has reverse setting - in case NEC standard setting Drive is mounted to such reverse setting PC, Drive may not be recognized. Needs careful confirmation of Drive and PC.
2) Needs Bezel Figure Confirmation
Drive Bezel may not be compatible with the current drive. - Needs to confirm Bezel attachment form.
3) Connector/Enclosure form of Slim Drive
Since NEC Slim Drive is based on Standard, most Drives on market are compatible. However, some PC manufacturers may use connectors incompatible with NEC Drives - Needs prior confirmation for connector compatibility.

prese da http://www.nec.co.jp/products/optical/e ... ndex.shtml

Probabilmente non hai settato bene Master/Slave o Cable Select

SCUSA MA NON SONO CAPACE DI SETTARLO SE PUOI SPIEGARMI BENE I PASSAGGI DA SEGUIRE TE NE SAREI MOLTO GRATO GRAZIE

[quizface]

dovrei vedere il masterizzatore, Dietro ci dovrebbe essere qualche cosa, forse un ponticello. puoi fare delle foto?

[zizzi]

non sono capace ad inviarti le foto sul forum se vuoi posso inviartele via mail. grazie

[quizface]

metti le foto su ImageShack®
poi copia l'indirizzo Hotlink for forums nella risposta