Condividi:        

"A failure can be imminent"

Se il modem non funziona, hai problemi con la scheda video o non sai che processore scegliere entra qui!!

Moderatori: m.paolo, Caffey

"A failure can be imminent"

Postdi Carlito Brigante » 18/04/07 22:53

Ciao, da ieri il primo messaggio che mi accoglie quando accendo il pc è questo, legato al consiglio di fare subito un backup di tutto il disco. Fino ad ora ho scelto di proseguire ed il pc funziona regolarmente.
Lo scan con HDD Health dà questo risultato:

Drive model IC25N060ATMR04-0
Drive capacity 58,6 GB
Drive serial number MRG387K3V2V5ZH
Firmware revision MO3OAD4A
Number of cylinders 16383
Number of heads 16
Number of sectors per track 63
Number of LBA sectors 117210240
DMA support Enabled
LBA support Enabled
IORDY support Enabled
ATA software reset Not required
Overlap operation Not supported
Command queuing Not supported
Interleaved DMA Not supported
Multiword DMA mode supported Mode 2 and below
PIO transfer mode supported Mode 4
Minimum Multiword DMA transfer cycle time per word 120 ns
Manufacturer’s recommended Multiword DMA transfer cycle time 120 ns
Minimum PIO transfer cycle time without flow control 240 ns
Minimum PIO transfer cycle time with IORDY flow control 120 ns
ATA standard version ATA/ATAPI-6 and below
ATA realisation version ATA/ATAPI-6 T13 1410D revision 3a
SMART feature set Supported, Disabled
Security Mode feature set Supported, Disabled
Removable Media feature set Not supported
Power Management feature set Supported
PACKET Command feature set Not supported
Write cache Supported, Enabled
Look-ahead Supported, Enabled
Release interrupt Not supported
SERVICE interrupt Not supported
DEVICE RESET command Not supported
Host Protected Area feature set Supported
WRITE BUFFER command Supported
READ BUFFER command Supported
NOP command Supported
DOWNLOAD MICROCODE command Not supported
READ DMA QUEUED and WRITE DMA QUEUED commands Not supported
CFA feature set Not supported
Advanced Power Management feature set Supported, Enabled
Removable Media Status feature set Not supported
Power-Up In Standby feature set Supported, Disabled
SET MAX security extension Supported, Disabled
Automatic Acoustic Management feature set Supported, Disabled
48-bit Address feature set Supported
Device Configuration Overlay feature set Supported
FLUSH CACHE command Supported
FLUSH CACHE EXT command Supported
SMART error logging Supported
SMART self-test Supported
Media serial number field words Not supported
Media Card Pass Through Command feature set Not supported
Streaming feature set Not supported
General Purpose Logging feature set Supported
WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands Not supported
WRITE DMA QUEUED FUA EXT command Not supported
World wide name Not supported
URG bit for READ STREAM DMA and READ STREAM PIO commands Not supported
URG bit for WRITE STREAM DMA and WRITE STREAM PIO commands Not supported
Time-limited Read/write feature set Not supported
Read Continuoud and Write Continuous in the Time-limited Read/write feature set Not supported
Ultra DMA mode selected Mode 5
Ultra DMA mode supported Mode 5 and below
Time required for Enhanced security erase unit completion Value not specified
Advanced power management level value 128
Master Password Revision Code Not supported
Device vendor’s recommended acoustic management level 254
The current automatic acoustic management level 128
Removable Media Status Notification feature set Not supported
Enhanced security erase unit feature Not supported
The security count is expired and SECURITY UNLOCK and SECURITY ERASE UNIT are command aborted until a power-on reset or hardware reset.
CFA Power Mode Mode 1
Maximum average RMS current 32 Milliamperes

Start/Stop Count (Power on count) 1480 times
Reallocated Sectors Count 0 sectors
Power-On Hours 4337 minuties (hours)
Device Power Cycle Count 1463 times
Temperature 41 °C
Reallocation Event Count 3709 events
Current Pending Sector Count (Unstable sectors) 166 sectors
Uncorrectable Sector Count 0 sectors
UltraDMA CRC Error Count (total) 0 errors


Alla voce "health" mi dice che non ci sono errori conosciuti sul drive.

Ora, vorrei capire se sto veramente perdendo il disco e se posso fare qualcosa prima di pensare a un drive esterno e al backup di 30 giga di file...

Grazie!
"...You think you're like me? You ain't like me motherfucker, you're a punk. I've been with main people, connected people...who have you been with? Chains snatching, jive-ass, maricòn motherfuckers..."
Carlito Brigante
Utente Senior
 
Post: 247
Iscritto il: 26/04/03 14:25
Località: Milano

Sponsor
 

Postdi vinsecci » 19/04/07 11:42

A me il portatile mi è caduto da un'altezza di circa un metro ed è lo stesso messaggio che mi è apparso dopo che lo riacceso per la prima volta... Però è passato più di un anno e oltre a non rivedere più quella schermata l'hard disk non è ancora andato in panne (per il momento :D )

Sono molto fortunato, magari non è il tuo caso. Fai un backup completo se hai dati importanti, altrimenti prova a lasciar correre... Se il tuo pc è anzianotto allora il tuo hd prob è usurato... Il mio era nuovo quando è successo :eeh: .

Bello il tuo avatar ;) E uno dei miei film preferiti.[/quote]
vinsecci
Newbie
 
Post: 8
Iscritto il: 25/01/07 13:36


Torna a Assistenza Hardware


Topic correlati a ""A failure can be imminent"":


Chi c’è in linea

Visitano il forum: Nessuno e 60 ospiti