Condividi:        

aggiornamento BIOS

Hai problemi con i file Zip, vuoi formattare l'HD, non sai come funziona FireFox? O magari ti serve proprio quel programmino di cui non ricordi il nome! Ecco il forum dove poter risolvere i tuoi problemi.

Moderatori: Dylan666, hydra, gahan

aggiornamento BIOS

Postdi pirlotto61 » 02/11/06 16:10

Buongiorno a tutti.
Ho visto tramite Everest che il BIOS era vecchio.
Mi sono collegato per l'aggiornamento, ho ricevuto il file zip, l'ho messo su floppy, ho impostato su CMOS A come first boot device ma quando riavvio non aggiorna niente.
Chi mi può aiutare?
pirlotto61
Utente Junior
 
Post: 12
Iscritto il: 18/01/06 19:39

Sponsor
 

Postdi quizface » 02/11/06 18:45

Di che scheda madre stiamo parlando? hai scaricato anche il programma per flashare? hai fatto un floppy disk bootable? il computer fa il boot dal floppy driver
Se non siete sicuri di quello che scrivete, non scrivete niente, nessuno vi obbliga ed eviterete di confondere chi gia' e' confuso. Ciao..ciao
Avatar utente
quizface
Utente Senior
 
Post: 15071
Iscritto il: 03/10/04 00:36

Postdi pirlotto61 » 02/11/06 19:02

Salvami.
La scheda è ECS KM400-M2.
Il programma per flashare? Cos'è?
Sul floppy ho messo l'aggiornamento che mi hanno mandato, ma che sia bootable non lo so.
Si capisce che non so niente di PC?
Ciao.
pirlotto61
Utente Junior
 
Post: 12
Iscritto il: 18/01/06 19:39

Postdi hydra » 02/11/06 19:21

Ma dove hai preso il bios non ci sono le istruzioni per installarlo?
Avatar utente
hydra
Moderatore
 
Post: 7007
Iscritto il: 19/07/04 08:06
Località: Vallis Duplavis

Postdi pirlotto61 » 02/11/06 19:25

Innanzitutto: grazie Quizface per l'interessamento.
Grazie Hydra per aver risposto.
Il BIOS è un Award, le istruzioni ci sono e le ho seguite:
copiato su floppy-riavvio con dischetto inserito ma alla prima schermata mi dice di rimuoverlo quando nelle istr. sembra che faccia tutto da solo.
Come devo fare?
pirlotto61
Utente Junior
 
Post: 12
Iscritto il: 18/01/06 19:39

Postdi hydra » 02/11/06 19:34

Mah, prova a postare qui le soluzioni o un link dove le hai prese, vediamo se è tutto ok.
Avatar utente
hydra
Moderatore
 
Post: 7007
Iscritto il: 19/07/04 08:06
Località: Vallis Duplavis

Postdi pirlotto61 » 02/11/06 19:36

Step 1
------
Turn on your computer, enter CMOS setup by pressing the delete (del) key
during the Boot Sequence, and set the first boot device to be A: (floppy)
Save settings and exit by pressing F10.

Step 2
------
Shut down the system, and then insert eSupport BIOS Flash Upgrade Disk.

Step 3
------
Reboot the system.

Step 4
------
The program will perform the flash automatically. When asked to continue or
quit, press any key to continue. Do NOT reset or turn off the computer during
the flash process or your BIOS may be damaged.

Step 5
------
When the flash is finished, you will be prompted to quit the program or
restart the system. Choose to restart the system. (Make sure that the flash
disk has been removed).

Step 6
------
Your system has now been flashed with the new eSupport BIOS upgrade. You
should see the new BIOS version displayed on the screen during bootup. Press
the Delete key to setup your BIOS again if necessary.
pirlotto61
Utente Junior
 
Post: 12
Iscritto il: 18/01/06 19:39

Postdi hydra » 02/11/06 19:40

Beh, chiarissimo. E il floppy come lo crei? Hai istruzioni in merito?
Avatar utente
hydra
Moderatore
 
Post: 7007
Iscritto il: 19/07/04 08:06
Località: Vallis Duplavis

Postdi pirlotto61 » 02/11/06 19:46

Istruzioni zero.
Ho creduto di fare bene estraendo lo zip e copiarlo sul floppy.
Ed ho creduto male.
Ora cercavo come si fa un floppy "bootable" ma o non è chiaro o non capisco niente.
pirlotto61
Utente Junior
 
Post: 12
Iscritto il: 18/01/06 19:39

Postdi hydra » 02/11/06 19:54

Linkaci il sito dove hai preso quel file.
Avatar utente
hydra
Moderatore
 
Post: 7007
Iscritto il: 19/07/04 08:06
Località: Vallis Duplavis

Postdi pirlotto61 » 02/11/06 20:09

pirlotto61
Utente Junior
 
Post: 12
Iscritto il: 18/01/06 19:39

Postdi pirlotto61 » 02/11/06 20:56

Risolto.
Sempre su esupport.com ho trovato il programma per flashare (http://www.esupport.com/techsupport/awa ... dutils.htm), quindi ho reso il floppy bootable e tutto è andato bene. Grazie ancora.
pirlotto61
Utente Junior
 
Post: 12
Iscritto il: 18/01/06 19:39


Torna a Software Windows


Topic correlati a "aggiornamento BIOS":


Chi c’è in linea

Visitano il forum: Nessuno e 108 ospiti