Scarica questo...
http://www.memtest86.com/memtest86-3.0.iso.zip
Il manuale ha scritto:Install Memory Modules
This mainboard accommodates 184-pin 2.5V unbuffered
Double Data Rate (DDR) SDRAM memory modules. The
memory chips must be standard or registered SDRAM (Synchronous
Dynamic Random Access Memory).
The memory bus can run at 100 MHz or 133 MHz. If your
processor operates over a 100 MHz system bus, you can install
PC100 or PC133 memory modules that operate over a
100 MHz or 133 MHz memory bus. If your processor operates
over a 133 MHz system bus, you can only install PC133
memory modules that operate over a 133 MHz memory bus.
Il manuale ha scritto:Current FSB Frequency
This item displays the frontside bus (FSB) frequency. This is a
display-only item. You cannot make changes to this field.
Current DRAM Frequency
This item displays the memory (DRAM) frequency. This is a
display-only item. You cannot make changes to this field.
DRAM Clock (100 MHz)
This item enables you to manually set the DRAM Clock. We
recommend that you leave this item at the default value.
DRAM Timing (By SPD)
Set this to the default value to enable the system to automatically
set the SDRAM timing by SPD (Serial Presence Detect).
SPD is an EEPROM chip on the DIMM module that stores information
about the memory chips it contains, including size,
speed, voltage, row and column addresses, and manufacturer.
If you disable this item, you can use the following three items
to manually set the timing parameters for the system memory
SDRAM Cycle Length (3)
When synchronous DRAM is installed, the number of clock
cycles of CAS latency depends on the DRAM timing. We recommend
that you leave this item at the default value.
Bank Interleave (Disabled)
Enable this item to increase memory speed. When enabled,
separate memory banks are set for odd and even addresses
and the next byte of memory can be accessed while the current
byte is being refreshed.
DRAM Command Rate (2T Command)
This item enables you to specify the waiting time for the CPU
to issue the next command after issuing the command to the
DDR memory. We recommend that you leave this item at the
default value.
piercing ha scritto:non vorrei dire boiate ma una DDR pilotata a 166 dovrebbe girare a 333...
Consiglio ultrabook content creator 1500/2000euro - windows Autore: nonsonoio |
Forum: Consigli per gli acquisti Risposte: 13 |
Visitano il forum: Nessuno e 26 ospiti